CAN/CSA-B149.1-05 - Amendment FS-135-08
- Friday, June 13 2008 @ 09:17 pm UTC
- Views: 5,151
Amendment to the Gaseous Fuels Code Adoption Document
Ammendment FS-135-08
*Click image to enlarge.
The Director of Ontario Regulation 212/01 (Gaseous Fuels) pursuant of section 6 of Ontario Regulation 223/01 (Codes and Standards Adopted by Reference) hereby provides notice that the Gaseous Fuels Code Adoption
Document published by the Technical Standards & Safety Authority, dated June 1, 2001 and amended on June 15, 2007, is further amended as follows:
1. Section 1.28 is revoked and the following substituted for it:
1.28 Clause 8.9.6 is revoked and the following substituted for it:
8.9.6 (a) Until October 1, 2008, vents constructed using plastic piping shall be certified to ULC S636 except for special fittings (non standard venting systems and components), which may include:
a. entire vent systems supplied with the appliance that are not comprised of standard vent sizes and components;
b. transitions with or without condensing lines; and
c. termination kits.
8.9.6 (b) After October 1, 2008, venting systems constructed using plastic piping shall be certified to ULC S636.
2. This amendment is effective immediately.
Dated at Toronto this 13th day of June, 2008.
Ammendment FS-135-08
*Click image to enlarge.
The Director of Ontario Regulation 212/01 (Gaseous Fuels) pursuant of section 6 of Ontario Regulation 223/01 (Codes and Standards Adopted by Reference) hereby provides notice that the Gaseous Fuels Code Adoption
Document published by the Technical Standards & Safety Authority, dated June 1, 2001 and amended on June 15, 2007, is further amended as follows:
1. Section 1.28 is revoked and the following substituted for it:
1.28 Clause 8.9.6 is revoked and the following substituted for it:
8.9.6 (a) Until October 1, 2008, vents constructed using plastic piping shall be certified to ULC S636 except for special fittings (non standard venting systems and components), which may include:
a. entire vent systems supplied with the appliance that are not comprised of standard vent sizes and components;
b. transitions with or without condensing lines; and
c. termination kits.
8.9.6 (b) After October 1, 2008, venting systems constructed using plastic piping shall be certified to ULC S636.
2. This amendment is effective immediately.
Dated at Toronto this 13th day of June, 2008.